package mirage-stack

  1. Overview
  2. Docs

Module type Mirage_stack.V6Source

Sourcetype t

The type representing the internal state of the IPv6 stack.

Sourceval disconnect : t -> unit Lwt.t

Disconnect from the IPv6 stack. While this might take some time to complete, it can never result in an error.

Sourceval udp : t -> UDP.t

udp t obtains a descriptor for use with the UDPV6 module, usually to transmit traffic.

Sourceval tcp : t -> TCP.t

tcp t obtains a descriptor for use with the TCPV6 module, usually to initiate outgoing connections.

Sourceval ip : t -> IP.t

ip t obtains a descriptor for use with the IPV6 module, which can handle raw IPv6 frames, or manipulate IP address configuration on the stack interface.

Sourceval listen_udp : t -> port:int -> UDP.callback -> unit

listen_udp t ~port cb registers the cb callback on the UDPv6 port and immediately return. If port is invalid (not between 0 and 65535 inclusive), it raises Invalid_argument. Multiple bindings to the same port will overwrite previous bindings, so callbacks will not chain if ports clash.

  • deprecated use UDP.listen instead (since mirage-protocols 6.0.0).
Sourceval listen_tcp : ?keepalive:Mirage_protocols.Keepalive.t -> t -> port:int -> (TCP.flow -> unit Lwt.t) -> unit

listen_tcp ~keepalive t ~port cb registers the cb callback on the TCPv6 port and immediately return. If port is invalid (not between 0 and 65535 inclusive), it raises Invalid_argument. Multiple bindings to the same port will overwrite previous bindings, so callbacks will not chain if ports clash. If ~keepalive is provided then these keepalive settings will be applied to the accepted connections before the callback is called.

  • deprecated use TCP.listen instead (since mirage-protocols 6.0.0).
Sourceval listen : t -> unit Lwt.t

listen t requests that the stack listen for traffic on the network interface associated with the stack, and demultiplex traffic to the appropriate callbacks.